This side-address microphone is most sensitive to sounds arriving from in front of it while picking up much less of sounds arriving from the sides or rear (from monitor speakers or neighboring instruments). This makes the microphone equally suited for recording and onstage use.

The 0.67" diaphragm—sized between the measurements of typical large and small diaphragms—is made of a plastic foil that is gold-sputtered on one side only to prevent shorting to the back electrode even at extremely high sound pressure levels.

The all-metal body adds to the rejection of RF interference so you can use the microphone near transmitter stations and along with wireless microphones or other communications equipment. The extremely rugged, heavy body and sturdy front grille protect the microphone from damage from tough handling on stage.

Capable of handling sound pressure levels up to 150 dB without introducing perceptible distortion and built to resist high temperatures and humidity, the microphone will give excellent results in a wide range of applications.

Selector 1 on the microphone front further reduces low-end distortion caused by footfall, wind noise, and air conditioning rumble. The filter also minimizes the proximity effect that close-in miking from less than 4" causes in any unidirectional microphone. The filter rolls off at 6 dB/octave from 300 Hz downward.

Selector 2 on the microphone front lets you increase the headroom by 20 dB for distortion-free recording up close. The pre-attenuation pad prevents the microphone's output level, particularly at low frequencies, from overloading the miniature transformers used in many mixer input stages, etc.

The P120 uses a condenser transducer designed for 48V phantom powering from a source such as an external mic preamp, an audio interface, or a mixing console. It provides a balanced output on an XLR 3-pin male connector; use an XLR cable (available separately) to connect the microphone to a balanced XLR input with phantom power.